• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DRIVE strength and SLEW rate in Alchitry Labs
With the Mojo v3 in the old IDE, you could adjust the pin IO standard, pullup/down resistors, slew rate, and drive strength in the .ucf file as shown here.

In Alchitry Labs, you edit a .acf file, but the only allowed keyword is "pullup" or "pulldown". How do I change the DRIVE strength parameter in Alchitry Labs? 
The relevant Xilinx 7-series SelectIO document is here on page 48.


Forum Jump:

Users browsing this thread: 1 Guest(s)