Could not detect an Au!

[satheesh_s]

This makes me think SparkFun may have missed programming the FTDI chip. Did your board turn on with the LED wave pattern when you first got it?

I attached the FT_PROG config for the Au so you can flash it to factory settings.

Connect the board and detect it like before but then go to FILE->Open Template and open the attached file.

Then click the lightning bolt and click Program to flash it.

You can then do another "Scan and Parse" to make sure it shows up correctly.

When I connect my Au to the PC, the LED wave pattern does show up and also blinks the alternate LEDs when I press the switch.  But it did not recognize the device.


Thanks for the template file.  I have programmed my device with this template file and I can flash my device now using Alchitry Labs and Loader.