• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Unable to upload sketch to Mojo v3
#3
This can happen on Linux if you don't have the proper udev rules setup as a service (I forget its name) will take over the board thinking it is a modem for a few minutes after it resets which prevents it from showing up properly. The udev rules file is included in the Mojo Loader download.

On Windows this usually happens if the driver isn't loading for the bootloader. You can check this by manually resetting the board (temporarily jump the GND and RST pins on the back with a small piece of wire) and seeing if it shows up as an unknown device or as a COM port.

[Image: mojo-v3-prog-pins.jpg?v=1516305840]
  Reply


Messages In This Thread
Unable to upload sketch to Mojo v3 - by RedPants - 05-16-2020, 04:25 AM
RE: Unable to upload sketch to Mojo v3 - by alchitry - 06-15-2020, 07:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)