• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mojo-ide issue
#1
I have a Mojo v3 board. I have set up the Xilinx ISE and installed Mojo-ide on Ubuntu 19.10 running in a VM on a Toshiba Laptop.

The Xilinx software runs fine. I have been doing exercises from Simon Monk's book "Programming FPGAs"
The Mojo-ide seems to work Ok I created a Project using the LEDtoButton Lucid file. I click on the mojo_top.luc and the file is displayed. I have setup the ISE location.

But when I attempt to build the project by selecting the hammer icon, after a few lines I get the following error message on the console in mojo-ide
"application: specific initialization failed: couldn't load file "librdi_commontasks.so": libncurses.so.5: cannot open shared object file: No such file or directory"

After using $sudo find command, these files exist on the ubuntu VM.
I have tried to google a solution without success 
I think it is a path problem but I can't figure it out.
Any help would be much appreciated.
  Reply


Messages In This Thread
Mojo-ide issue - by fmentiplay - 01-17-2020, 11:33 PM
RE: Mojo-ide issue - by fmentiplay - 01-19-2020, 10:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)