• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Designing an ESP32 MCU Shield
#2
I decided to make a prototype to test the feasibility of controlling the Au board with a microprocessor.  I currently have a Raspberry Pi Zero W connected to a Br breakout board.  I plan to use the RPi GPIO pins to transfer data to/from the Au using a custom 8-bit parallel I/O interface.  I could also use the serial UART lines as a fallback approach.  
So far, so good.
In general, I think it would be VERY useful to have a microcontroller/microprocessor shield for the AU board as it will help the adoption of FPGA technologies in the maker community.
  Reply


Messages In This Thread
Designing an ESP32 MCU Shield - by mark.vriesenga - 12-14-2019, 11:17 PM
RE: Designing an ESP32 MCU Shield - by mark.vriesenga - 12-28-2019, 08:58 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)