• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't get the Cu to work...
#1
Hi all,

A question from an FPGA newbie: I bought a Cu, installed Alchitry Labs & IceCube2,and configured Labs so it knows where IceCube2 and the license file are located. Plugging in the Cu gives me a short flash of the 'Done' LED; voltage on the test points is 4.7V)

I can building sample projects (HelloWorld, Led to Button) without any errors, same for flashing the Cu, but: no happ flashing LEDs of any kind...

Any hints/tips/...? Am I missing something?

Thanks in advance for any info!
  Reply


Messages In This Thread
Can't get the Cu to work... - by Gleekzorp - 03-19-2022, 02:33 PM
RE: Can't get the Cu to work... - by alchitry - 04-15-2022, 03:21 PM
RE: Can't get the Cu to work... - by Gleekzorp - 04-15-2022, 08:17 PM
RE: Can't get the Cu to work... - by alchitry - 07-05-2022, 03:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)