• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Could not detect an Au!
#4
This makes me think SparkFun may have missed programming the FTDI chip. Did your board turn on with the LED wave pattern when you first got it?

I attached the FT_PROG config for the Au so you can flash it to factory settings.

Connect the board and detect it like before but then go to FILE->Open Template and open the attached file.

Then click the lightning bolt and click Program to flash it.

You can then do another "Scan and Parse" to make sure it shows up correctly.


Attached Files
.xml   alchitry_au_ft_prog.xml (Size: 4.28 KB / Downloads: 25)
  Reply


Messages In This Thread
Could not detect an Au! - by satheesh_s - 11-06-2020, 01:15 AM
RE: Could not detect an Au! - by alchitry - 11-06-2020, 03:46 PM
RE: Could not detect an Au! - by satheesh_s - 11-07-2020, 05:15 AM
RE: Could not detect an Au! - by alchitry - 11-09-2020, 05:44 PM
RE: Could not detect an Au! - by satheesh_s - 11-11-2020, 12:07 AM
RE: Could not detect an Au! - by alchitry - 07-22-2021, 02:20 PM
RE: Could not detect an Au! - by satheesh_s - 07-23-2021, 01:51 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)