• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Could not detect an Au!
#1
I have setup Alchitry Labs 1.2.1 on my Windows 10 machine.  I have connected Au to the machine and under UBS Controllers in Device Managers, I do see 2 entries - USB Serial Converter A and USB Serial Converter B.  Both of them show the driver being used as FTDI.

Even after this, both Alchitry Labs and Alchitry Loader do not recognize this and the status is always - 'Could not detect an Au!' when I try flashing on to the device.

I did uninstall the devices from Device Manager with the Option for 'Uninstall Drivers' set to on.  But after I disconnect and connect Au to the PC, the default it took was the same FTDI with no change.

Is there anything else I need to do make Alchitry Labs and Loader recognize the Au?
  Reply


Messages In This Thread
Could not detect an Au! - by satheesh_s - 11-06-2020, 01:15 AM
RE: Could not detect an Au! - by alchitry - 11-06-2020, 03:46 PM
RE: Could not detect an Au! - by satheesh_s - 11-07-2020, 05:15 AM
RE: Could not detect an Au! - by alchitry - 11-09-2020, 05:44 PM
RE: Could not detect an Au! - by satheesh_s - 11-11-2020, 12:07 AM
RE: Could not detect an Au! - by alchitry - 07-22-2021, 02:20 PM
RE: Could not detect an Au! - by satheesh_s - 07-23-2021, 01:51 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)