• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question Shield Mojo to Alchitry
#1
Hello
I'm designing a circuit to make sure that the new Architry board shields can be mounted on Mojo V3.
Is it necessary that the wires from the mojo connectors to the new smd connectors have the same length?
From the photo of alchity Au the wires of equal length are the ones that go to the dram onboard but the ones that go to the connectors do not seem to me to be identical in length. Is that so?
In this last case it is not necessary that in the design of the pcb you implement the wires of equal length.

The attached file shows the board with 2 connectors with wires of identical length. But to make all 4 connectors the thing is quite complicated. It can be done but I have to waste some time.

I hope I have explained

Fabio
  Reply


Messages In This Thread
Question Shield Mojo to Alchitry - by tistructor - 09-10-2020, 12:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)