• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Alchitry Labs -> Alchitry Loader
#1
So I was using Alchitry Loader fine in the beginning, both interface 0 and 1 were FTDI driver.

Then I used zadig to change Interface 0 to WinUSB, and I was able to use Alchitry Labs to interact with the board.

But then I tried to switch back to Alchitry Loader again, it seems I just can't get it working whatsoever. I tried to delete the driver from device manager, tried all kinds of drivers in Zadig, I just couldn't reset the Driver to the propriatary FTDI driver and couldn't program the board with Alchitry Loader, it always says Can't Find Device.

Any suggestions? Thanks
  Reply


Messages In This Thread
Alchitry Labs -> Alchitry Loader - by ramonae86 - 08-27-2020, 07:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)